SATA+10/100/1000 Combo  
Part No. 1016-0019-000A
Key Features & Benefits:
Combo card design adds SATA (1.5Gbps) and 10/100/1000BASE-T Ethernet interface into your computer at once!
Breaks the 137GB barrier! Supports various brands of large capacity Serial ATA hard disk drives
Provides auto-sensing feature for full-duplex operations at 10Mbps, 100Mbps and 1000Mbps
System Requirements:
Pentium III or equivalent PC computer with one available PCI slot
Windows® 98SE or later
Specifications:
Version: v1.0
Regulatory approval(s): FCC Class B (DoC) and CE (1998)
Chip set : SATA-Silicon Image SiI3512, Gigabit Ethernet-Realtek 8169S
OS support: Windows® 98SE/ME/2000/XP
Bus type: 32-bit PCI
Port type 1: 1 external and 1 internal Serial ATA ports
Port type 2: single shielded RJ-45 connector
Full compliant with PCI Plug-n-Play 2.2
Built-in 4-pin power connector can be used to receive extra power supply from syste
Hot-swapping feature allows you to connect/disconnect devices without first powering down the system
Full compliant with PCI Plug-n-Play 2.2
Serial ATA interface:
  - Compliant with Serial ATA Specification, revision 1.0
- Provides two independent channels to connect up to two Serial ATA hard disk drives
- Supports Serial ATA data transfer rates up to 150 MB/s (1.5Gb/s)
- Features independent 256-byte FIFOs per channel for host reads and writes
- Features Watch Dog timer for fault resiliency
- Supports Serial ATA hard disk drive larger than 137GB
- Lower pin count and voltage requirement, plus better cabling over traditional
- Parallel ATA make Serial ATA the controller of the future
10/100/1000 Gigabit Ethernet interface:
  - Fully compliant with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
- Compliant with Media Access Controller (MAC) with triple-speed 10BASE-T, 100BASE-TX and   1000BASE-T Ethernet on standard Category 5 UTP
- Provides Wake-On-LAN and ACPI features to achieve the most efficient power management
- Supports Crossover Detection and Auto-Correction to provide robust transmission and reception capability at high speeds
- Full-duplex operation at 10Mbps, 100Mbps and 1000Mbps auto-sensing feature
- Self diagnostic LED mounted RJ-45 connector for easily viewing and troubleshooting
- Single shielded RJ-45 connector for using at all speeds
Package Contents:
SATA+10/100/1000 Combo
Serial ATA data cable
Serial ATA power cable
Quick installation quide
Driver software